Land Rover and Range Rover Forum banner
1 - 1 of 1 Posts

·
Registered
93 LWB KITTED 95 LWB Chop Top 03 D2
Joined
·
213 Posts
Setting The Potentiometer

you need a $500 dollar Potentiometer guage to adjust this.. Lucas part number YWB 121. But if you don't have one handy ( and who does???) you can use a VOLT meter... If you use a volt meter to carry this out make sure its set to VOLTS.. any other setting may result in dammage to the potentiometer (PM for short ) 1) loosen the PM securing screws 2) switch ON the ignition 3) connect a voltmeter between the red and green leads at the PM electrical plug 4) rotate the PM clock or counter clockwise untlil the meter reads 290+or-20Mv. 5) tighten PM securing screws 6) re check the Voltmeter readings.

hope that helps...
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top