Land Rover and Range Rover Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
342 Posts
Discussion Starter · #1 ·
1990 RRC with abs

So my son starts this project, and I found myself in the middle of it......

putting new pads and rotors on the rear, the five small nuts come off to take the abs disc out, but the disc itself is scaled and rusted in place. In fact, if it weren't for common sense, I would think it is one piece. Any hints for getting it out so that I can separate the hub from the rotor?

Thanks
Rob
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top