Land Rover and Range Rover Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
Hey guys,
Got started on the rear diff on the D1 and this is as far as I got, with a broken puller to show for it.....
How do I get this off?? I dont see a nut at all.... just the yolk as you see it in the attached pic....
Any advice would be appriciated, but i dont want to diss the rear end and take the axles out, nothing wrong in there.... juzt not ready to do that. Previous posts
indicate that diff dissassembly isnt required for roto to solid shaft conversion...
:help..
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top