Land Rover and Range Rover Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
'04 Discovery... I replaced the rear wiper arm and blade, but now the wiper only makes contact with the window in the center where the arm is. The 2 ends of the blade miss the window. From all I can see, the blade is attached properly. The blade is made of plastic, so there is no way to bend it. Any suggestions for adjusting the blade?
 

·
Premium Member
Joined
·
1,737 Posts
It happens with aftermarket bits quite often, if the arm and blade are genuine you can try to replace the spindle's grommet + washer and tighten it to be in the middle cos if the grommet is worn the whole setup can become missaligned, (nr 2, 3 in this link : Allbrit.de - Ersatzteile für LAND ROVER & MG ROVER )
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top