Land Rover and Range Rover Forum banner
1 - 2 of 2 Posts

· Registered
10 Posts
Discussion Starter · #1 ·

i see two groups of bolts connecting the back end of the rear drive shaft to the differential. one group of 3 and a second group of 4 bolts. which group should i remove to most easily separate the back of the shaft from the differential.... the three or the two or should i take off all seven back there at the dif.

the manual mentions a flexible coupling flange back there and pinion flange.... whatever that is ..

I am putting the front of the rover on a tow dolly and want to separate the drive shaft


· Premium Member
82 Posts
Doesn't really matter. Just make sure you mark it so it goes back the same way.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.