Land Rover and Range Rover Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
35 Posts
Discussion Starter · #1 ·
Hey yall,



We just got finished replacing the kickdown cable on a ZF and after we put everything back together the RRC won't move. It doesn't even feel like the tranny is engaging [yes, I have the fluid back in it] and I am getting a little worried.



When I first cranked it up I heard a little rattling noise and within 3 seconds I turned it back off. Now when I crank it hear nothing and it does nothing.



We removed the entire valve body and were EXTRA careful. Is it possible that the small shaft piece attached to the valve body that has a little tit on it fits into the small hole on the end of the cable inside the ZF? We couldn't see to make it fit that way so we set it on top of the roller assembly and it seemed to fit correctly.



Any suggestions please???
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top