Land Rover and Range Rover Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
19 Posts
Discussion Starter · #1 ·
OK, I've gotten my new rotor and brake pads for my '98 Disco I. Is there anything else I'll be needing once I start pulling into this job. Seals, bearings or anything else I'll tear up or should replace while under there? Any and all help greatly appreciated. :buttrock:
 

· Registered
Joined
·
1,506 Posts
First thing you need is a hub tool (makes life a bit easier). Second thing you need is a BFH (big f'ing hammer). While you're at it you should repack the bearings with grease or just replace them. Make sure you have a tube of thread locker for the caliper bolts and hub cover. Here's a good write-up on replacing the front bearings.

Are you doing all four wheels or just the fronts?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top