Land Rover and Range Rover Forum banner
1 - 4 of 4 Posts

·
1993 range rover lwb - Roman Bronze
Joined
·
533 Posts
Discussion Starter · #1 ·
Hello everyone, I'm looking for the rubber moulding that connects the rear tail light guard. I know I'm suppose to drill two holes and use the screws to hold it in place but I didn't and because of it, it fell off.......soooo I need another one for the passenger side.
 

·
1993 range rover lwb - Roman Bronze
Joined
·
533 Posts
Discussion Starter · #3 ·
Not sure what you are looking for.

Are you looking for the tail light guard or the rubber piece which attaches to the side of the vehicle?

I'm looking for the rubber piece that attaches to the side of the vehicle. Automotive exterior Bumper Vehicle Tire Car


In the picture, the black strip is double sided tape, that's where the rubber piece used to be until it fell off.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top