Land Rover and Range Rover Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
For my '00 Dicovery II. Installed the Scan Gauge II after an engine rebuild and am very pleased. It reads the standard OBD info great. I've heard on the forums that it is possible to read the transmission temperature, but I'm not sure what coding to use to set the X-gauge function.

Any help would be appreciated.
Thanks in advance!!
 

·
Registered
Joined
·
454 Posts
Yeah, it would be great but it doesn't. I was hoping the same thing with my Ultragauge but from what I found out since the vehicle computer doesn't monitor the actual temperature of the transmission fluid it won't be available. There is a temperature sensor on the trans cooler but it's not a "monitored" sensor it's just an on/off sensor.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top