Land Rover and Range Rover Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi all and thanks in advance for any advice. I have a 1971 Series IIA (diesel) and noticed what I believe is coolant dripping on the floor when running the engine. It appears to be a pinhole leak in the cylinder head. Will JB Weld work as a temporary fix to seal up the leak for a few months until I can take on the larger project to address this? Is there any other products or solutions people can recommend?

93133
 

·
very disco
Joined
·
2,265 Posts
Welcome to the forum!
Im not sure the JB is a good solution for a hot, wet, pressurized application.

if it does work I’d love to hear about it
 
1 - 2 of 2 Posts
Top