Land Rover and Range Rover Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
I am doing the injector washers and O rings job on my car but I am kind of stuck now.

The new washers are genuine LR part but they wouldn't go past the mid point on the injector nozzles. Am I doing anything wrong? I have cleaned the tip using fine sand paper and there's no carbon left on the tips but that's not helping. I tried forcing them a little but to no joy.

Don't want to damage any thing since nothing is available here.... got these from Dubai as well.

Do I place the washers in the head first then install injector and use the clamp to seat them in place by tightening the bolt? Is that the correct way? Would that damage anything?

Also, I washed the injectors with petrol... is that okay??


Please help?!
 

Attachments

·
Registered
Joined
·
12 Posts
Discussion Starter · #2 ·
Any I have these questions too...

How do I clean the whole loom.. from the injector socket to the red socket?
How do clean the MAP sensor.. what and how to use?
My glow plug sockets were very brittle and I broke all 4 of them while removing them.... whats the fix?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top