Land Rover and Range Rover Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
102 Posts
Discussion Starter · #1 ·
Just purchased rock sliders from Atlantic British. I purchased the terrafirma sliders with tree bars. Has anyone installed these before on their D2? They came with nutserts, but I'm not sure if they are required or exactly the fitting process. I currently have the driver side up in place and was planning on just drilling out the holes on the inside, and then installing the bolts with washers while keeping the slider in place.

If I need to use the nutserts, what are the steps involved? I suppose I can just pilot the holes on the inside, lower the sliders, and then drill the holes out on both the inside and outside to fit the nutserts. But then do I install the nutserts before raising the sliders back up because they don't fit through the factory holes in the sliders.

Any thoughts?

Thanks!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top