Land Rover and Range Rover Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
Trying to set the timing on a 94 D90 NA. Can anyone tell me where the distributor clamp bolt is?

In the manual is mentions the possibility of overheating due to timing. I knao the timing is off a little, but can this really make it overheat?

I had it in to the dealer for pressure test and they recommended a new radiator, which was needed. I replaced that and the thermostat. Its cooling better now, but still overheats at idle. Given it is about 102 deg F here.

I've checked the viscous fan and it seems OK - good resistance but not seized.

Anything else to check?

Thanks
Michael
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top