[Dane!]

My computer is bein loaned out right now, so I have to access to the rave, just my telephone. I just pressed in new bearings for my idler pulleys and I was wondering how much should I torque the bolts in the engine? Thanks

 

[hafaday]

Auxiliary drive belt tensioner 45 Nm (33 lbf.ft)
Jockey pulley 50 Nm (37 lbf.ft)

Edit:
The jockey pulley IS the 2 idler pulleys. Rave says one thing, then calls it another.

 

[Dane!]

The belt tensioner wasn't taken off, the smaller and larger metal pulleys were removed. The jockey pulley is the pulley on te tensioner? If I'm. If I'm not mistaken. I'm lookin for those two specs.

 

[hafaday]

The belt tensioner wasn't taken off, the smaller and larger metal pulleys were removed. The jockey pulley is the pulley on te tensioner? If I'm. If I'm not mistaken. I'm lookin for those two specs.

The Rave calls the two idler pulleys "jockey pulleys". 1 is located above the power steering pump, the other right under the belt tensioner. if these are the two that you are referring to.. 37ft. lbs.

As for the spinning wheel on the actual tensioner..... you got me.

Edit:
The rave calls the same pulleys "idler pulleys" in the belt diagram. hence the says one thing and calls it another.

 

[Dane!]

Gotcha torqued em down ! Thanks for your help !