Land Rover and Range Rover Forum banner
1 - 6 of 6 Posts

· Premium Member
Joined
·
10,167 Posts
Is there a lot of pressure on the t-case right now? try to put in in reverse and take some pressure off....Or are you stuck in nuetral and 4-low?
 

· Registered
Joined
·
5,468 Posts
YES! But get underneath and spray everything down with WD-40 and just keep working the linkage like a virgin on her wedding night. Sorry, was thinking about my ex-wife for a second. :eek: But anyways, put it in neutral. If you are putting the CDL on, you don't have to put it in neutral, just slow down a bit. But for switching between hi and lo, yes, Neutral.
 

· Premium Member
Joined
·
10,167 Posts
roverX said:
YES! But get underneath and spray everything down with WD-40 and just keep working the linkage like a virgin on her wedding night.
:lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol:

Just not right...LOL.....
 

· Registered
Joined
·
55 Posts
Discussion Starter · #6 ·
I am so stupid, I shifted it into nutural, and then the differental shifted fine, alittle hard but fine over all. With out driving it, is there a way to tell if the tranny is fine. Thanks all.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top