Land Rover and Range Rover Forum banner

What to use to clean cylinder heads/block

1K views 3 replies 2 participants last post by  redtruck12 
#1 ·
What is the general consensus (if there is one) on what to use to clean the cylinder heads (already resurfaced) and the block before I replace the gasket?
 
#3 ·
I always use a good flat wide steel blade gasket scraper, carefully to not gouge anything and no abrasive sanding discs. Should feel smooth and then check with a good straightedge
 
#4 ·
If the heads are resurfaced they should not need anything more than a good wipe down
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top