Land Rover and Range Rover Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
145 Posts
Discussion Starter · #1 · (Edited)
Where did you put your auxiliary gauges?

I'm nearing the end of my 4.0 rebuild project (long and painful story) and I'm going to be installing a couple of auxiliary gauges for water temperature and oil pressure. I'm trying to figure out where to place these and in what sort of an enclosure to put them in for a nice, finished appearance.

I like these A-pillar pods, but I can't figure out how to do it with that tweeter (speaker) there, unless I relocate the tweeter to the instrument pod. Have to think about that.



So, if you have aux. gauges, where did you put them, and what enclosure did you use? A picture or two, if you can, would be great.

Thanks!
 

·
Registered
Joined
·
145 Posts
Discussion Starter · #3 ·
Wow! Yeah, the custom install is beautiful but that's more trouble than I'm willing to go to on it. Thanks for the reply.

FWIW, I've tried searching the forum for ideas, but I didn't find either of those. Thanks again.

Now back to buttoning up the engine before I reinstall it...
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top